Reference
materials of decorating guns, fluorescent lamps, cooling device,
sand mixer, blasting tubes, etc.
Options of types of parts →
Decorating
guns
1.
Applicable to bow-sized local blasting and
decoration.
2. Cost-effective, simple operation.
3. Even if connected to pressurized air it
still can be used.
4. Nozzle diameter:Φ4mm
5. Nozzle material: tungsten carbide
6. Capacity of sand: 250 cc
7. HP of air compressor required: 2 HP.
Dust-and-water-proof
fluorescent lamp set
1.
Built-in
electronic stabilizer without the
use of a starter.
2.
100%
water and dust proof.
3.
Specification:
20W with 100V and 220V.
4.
Standard-type,
L x W x H= 780x70x75mm
5.
Application:
a.
All
types of blasting machines and
walk-in-type blasting chambers,
etc. Lighting for dust application
equipment and location.
b.
Lighting
for all types of industrial
machines and equipment.
c.
Lighting
for fish tank.
Anti-blasting
helm/ coolers
Transient
controller/ sand mixer
Anti-blasting helm: Provided with
the breathing tube connector and connected
to pressurized air outside for breathing.
Coolers:
Applying
the principal of pressurized air expansion
and heat-absorbing, the operator can
adjust the temperatures by himself,
which may be reduced to minimum around
10 ℃ for the breathing air.
1.
The
transient controller can control the
opening and closure of blasting operation
by releasing and pressing the blasting
tube.
2.
Select
either the trigger or the pedaling switch
according to use.
3.
When
provided with a transient control device,
releasing the trigger or pedal switch
will not automatically release pressure.
To release the pressure tank, proceed
manually.
4.
When
provided with a transient control device,
the pressure tank will keep the pressure
anytime for saving pressure-increasing
time and for the blasting operation
to start faster.
5.
When
provided with a transient control device,
it will not automatically release pressure
and can thus save pressurized air. Applicable
to the remote-control blasting of large-sized
pressure tanks.
Blasting
tubes
For
pressurized blasting systems (reference data):
Inner
hole 1 inch (25.4mm), outer diameter (39mm)
Inner hole 3/4 inch (19mm), outer diameter
(33mm)
Inner hole 1/2 inch (12.7mm), outer diameter
(26.5mm)
For
typical blasting systems (reference data):
Inner
hole 3/4 inch (19mm), outer diameter (27mm)
Inner hole 3/4 inch (19mm), outer diameter
(27mm）
Inner hole 5/8 inch (15.8mm), outer diameter（23mm）
Inner hole 1/2 inch (12.7mm), outer diameter（20.8mm）
Inner hole 3/8 inch (9.5mm), outer diameter
(15.7mm)
